Quickstart

If you have just purchased a phyCORE-RT1170 development kit, start your development here.

../_images/pb-07326-kit.png

Check the Board Configuration

The board should have been pre-configured during manufacturing, but we will double check it together as an exercise:

  • Press firmly down on the SOM with equal pressure on both sides to ensure that it is seated properly

  • Check that the boot switch S5 is set to boot the system from QSPI Flash.

../_images/pb-07326_bs-QSPI.jpg ../_images/pb-07326_S5-callout.png

Power the Board

  • Use the included USB-C 5V power supply to provide power to the phyCORE-RT1170 development kit’s X9 power connector. The system will automatically boot.

    ../_images/pb-07326_qs-x9-callout.png

Run the Blinky Demo

The phyCORE-RT1170 development kit comes preprogrammed with a demo that will initiate one LED on the SOM to flash when plugged in. It will host boot up with a prompt

*** Booting Zephyr OS build 8be8ae00ba52 ***

uart:~$ kernel version
Zephyr version 4.0.0
uart:~$

Note

For any technical questions, feel free to reach out to PHYTEC’s Support Portal!