.. _Quickstart-rt1170:

Quickstart
##########

If you have just purchased a phyCORE-RT1170 development kit, start your development here.

.. image:: ../../images/phycore-rt1170/pb-07326-kit.png
   :width: 600px

Check the Board Configuration
--------------------------------

The board should have been pre-configured during manufacturing, but we will double check it together as an exercise:

* Press firmly down on the SOM with equal pressure on both sides to ensure that it is seated properly

* Check that the boot switch S5 is set to boot the system from QSPI Flash.

.. image:: ../../images/phycore-rt1170/pb-07326_bs-QSPI.jpg
     :width: 200px
.. image:: ../../images/phycore-rt1170/pb-07326_S5-callout.png
     :width: 500px

Power the Board
-----------------

* Use the included USB-C 5V power supply to provide power to the phyCORE-RT1170 development kit’s X9 power connector. The system will automatically boot.

  .. image:: ../../images/phycore-rt1170/pb-07326_qs-x9-callout.png
     :width: 500px

Run the Blinky Demo
----------------------------

The phyCORE-RT1170 development kit comes preprogrammed with a demo that will initiate one LED on the SOM to flash when plugged in. It will host boot up with a prompt

.. code-block::

   *** Booting Zephyr OS build 8be8ae00ba52 ***

   uart:~$ kernel version
   Zephyr version 4.0.0
   uart:~$

.. include:: ../../common/support-disclaimer-us.rst