.. include:: ../substitutions.rst

.. |image-quickstart-bootup| image:: ../../images/phycore-imx7/pcm-061-qs-peripheral.webp
  :width: 500px
  :alt: Serial Connection

.. |image-boot-sd| image:: ../../images/phycore-imx7/pcm-061-boot-sd.webp
    :width: 250px
    :alt: SD Card Boot Switch

.. |image-bootswitch-closeup| image:: ../../images/phycore-imx7/pcm-061_S1.webp
    :width: 500px
    :alt: phyBOARD-i.MX7 Close-up of Boot Switch

.. |image-quickstart-devicemanager| image:: ../../images/phycore-imx7/pcm-061-qs-device-manager.webp
    :width: 500px
    :alt: Windows Device Manager

.. _Quickstart-7:

Quickstart
==========

.. include:: ../../common/quickstart/quickstart-intro.rst

..
    Basic Evaluation Requirements
.. include:: ../../common/quickstart/quickstart-basic-eval.rst

..
    Check the Board Configuration
.. include:: ../../common/quickstart/quickstart-board-check.rst

* Check that the Boot Switch Bank S1 is set to boot the |product| Development Kit from the SD Card:

..
    SD Boot Settings
.. include:: ../../common/quickstart/quickstart-sd-boot.rst

Serial Communication Setup
--------------------------

* Using the provided micro-USB Serial Cable, connect the X6 USB Debug Port on the PEB-D-RPI Expansion Board of the |product| Development Kit to an available USB port on your Host Machine. Next, connect an Ethernet cable from X8 on the development kit carrier board to a network switch that is connected to a DHCP-enabled network.

..
    Windows 10 Instructions
.. include:: ../../common/quickstart/quickstart-windows.rst

* You should see two COM Ports provided by the |product| Development Kit's FTDI USB to UART Bridge. **You will need the lower COM Port Number in the following steps in order to establish serial communication with Linux running on the target hardware.**

  * The |product| Development Kit configures two COM Ports; one for Linux running in the MAIN domain (Cortex-A7 compute cluster) of the i.MX7Dual processor, and the other for the MCU domain (reserved for the real-time co-processors).

..
    TeraTerm Instructions (continued from Windows 10 Instructions)
.. include:: ../../common/quickstart/quickstart-tera-term.rst

..
    Linux Instructions
.. include:: ../../common/quickstart/quickstart-serial-linux.rst

..
    Power the Board
.. include:: ../../common/quickstart/quickstart-power-board.rst

..
    Safe Shutdown
.. include:: ../../common/quickstart/quickstart-shutdown.rst