.. include:: ../substitutions.rst

.. |image-quickstart-bootup| image:: ../../images/phycore-am57x/pb-057948-quickstart_bootup.png
    :width: 800px
    :alt: phyCORE-AM57x Development Kit

.. |image-boot-sd| image:: ../../images/phycore-am57x/pb-057948_boot-sd.png
    :width: 250px
    :alt: SD Card Boot Switch Settings

.. |image-bootswitch-closeup| image:: ../../images/phycore-am57x/pb-057948-bootswitch_closeup.png
    :width: 250px
    :alt: S5 Boot Switch Location

.. |image-quickstart-devicemanager| image:: ../../images/phycore-am57x/pb-057948-quickstart-devicemanager.png
    :width: 500px
    :alt: Windows Device Manager

.. _Quickstart-57:

Quickstart
==========

.. include:: ../../common/quickstart/quickstart-intro.rst

..
    Basic Evaluation Requirements
.. include:: ../../common/quickstart/quickstart-basic-eval.rst

..
    Check the Board Configuration
.. include:: ../../common/quickstart/quickstart-board-check.rst

* Check that the Boot Switch Bank S5 is set to boot the |product| Development Kit from the SD Card:

..
    SD Boot Settings
.. include:: ../../common/quickstart/quickstart-sd-boot.rst

Serial Communication Setup
--------------------------

* Using the provided RS-232 Serial Cable, connect the X18 Serial Debug Port of the |product| Development Kit to an available USB port on your Host Machine.

..
    Windows 10 Instructions
.. include:: ../../common/quickstart/quickstart-windows.rst

* You should see one COM Port provided by the RS-232 Serial Cable. **You will need this Port Number in the following steps in order to establish serial communication with Linux running on the target hardware.**

..
    TeraTerm Instructions (continued from Windows 10 Instructions)
.. include:: ../../common/quickstart/quickstart-tera-term.rst

..
    Linux Instructions
.. include:: ../../common/quickstart/quickstart-serial-linux.rst

..
    Power the Board
.. include:: ../../common/quickstart/quickstart-power-board-yogurt.rst

..
    Safe Shutdown
.. include:: ../../common/quickstart/quickstart-shutdown.rst