phyCORE-RT1170

Technical documentation and resources for the phyCORE-RT1170 System on Module.

When beginning to consider the phyCORE-RT1170 SOM as a part of your system design, it can be a little difficult to know where to start. Here is a suggested work flow:

• Work through the FreeRTOS Development to setup your work environment and gain access to phyCORE-RT1170 specific board support.

• Look at the Quickstart first to boot the development kit and then head over to Interface Guides to help you exercise the hardware. Depending on your system requirements, this might be all you need to begin scripting and developing the basic functionality of your system directly on the target.

• The Booting Essentials guides will help to boot from other boot sources.

• If you are ready to begin writing custom applications on your target hardware, checkout the Application Development guides to help you get your projects started.

• Release Notes
• Quickstart
• Interface Guides
• Booting Essentials
• Application Development
• FreeRTOS Development
• Zephyr Development

Note

The SPI NOR Flash component (U12) on the SOM has recently been updated from IS25WP064A-JBLE to MX25U12832FM2I02. If your unit has the older SPI NOR, please contact PHYTEC Support to receive new hardware.

The SPI NOR Flash (U12) is located in the top left corner of the SOM. Please refer to the component placement diagram below to identify which SPI NOR is populated on your unit.